The inside as been part lined ply tong and grove and would make a good D.I.Y projec Viewing high.This boat is 8ft wide and will not go through single gate locks
QR Code Link to This Post
Shell 20” Draft
Hull & cabin steelwork Bottom plts & counter 10mm. Hull side’s 6mm. Cabin side & roof 4 mm with 75mm curvature.
Knees & stringers 60 x 60 x 6mm. 620mm centers.
Cabin framing 25 x 25 x 5mm angle full length off sides.
Cabin roof 25 x 50 Channel 610mm centers
Diesel tank integral 40 Lts (approx) pressure tested & vented.
Water tank 1.5mm stainless steel 30 gallons (approx)
Gas locker forward or aft.
Rubbing strakes 50 x 12 S.E.H.R. fully welded.
Rudder & tiller 38mm dia balanced blade top bearing mount.
Weed hatch signal locking bolt quick release type.
Sundries 2 stern dollies & 1 bow tee.
The hull will be painted with a bitumen based paint to the rubbing strakes all other surfaces will be primed.
4 windows standard hopper window in bright gold finish concealed fixings
3 of 30" x 21" 1 of 18" x 21" obscure glass.
Ballast & floor will be concrete paving slabs placed under floor which consists of 18mm plywood laid on 25 x 75mm bearers.
Engine Vetus M2C5 11HP fitted & running.
inside part lined ply tong and grove