Lyrec PTR-1 Frida.
QR Code Link to This Post
Extremely hard to find another one in this mint condition
It's a piece of ingeneering art.
REC level and Eq are adjustable for each channel, for each speed for PB and for REC and Bias is adjustable for each channel/for each speed.
Runs at three speeds: 3.75ips; 7.5ips; 15ips.
With fully adjustable pitch control it also runs up to 48 ips.
Display switchable between Real Time Counter and speed read out.
Shows also pitch speed.
It has head wear protection in cue function.
Takes 11,8 inch/30 cm reels.
Real time counter w/two flags and goto, HX-Pro, IEC/NAB EQ, calibration in/out, fader start, editing board, remote controlled etc.
Remote control pin code in manual. You can build you own very advanced remote from that. It is modular built with insert cards and is really a piece of engineering art.
Control type: Full logic local and remote control
Max Spool size: 11 inch platters or 300mm reels (Only 1 can be 300mm)
Speeds: 3.75, 7.5 & 15 ips
Metering : 12 LED PPM metering
Speed acc: ±0.2%
Wind time: 70 seconds to wind 2400 feet
Reel type: Cine, NAB or DIN
Tape tension: 80g
Motors: 2 reel motors and one capstan motor
Heads: 3, erase, record and playback
Track configuration: stereo 1/2 track
Frequency response: 30Hz - 28KHz @ 15ips, 30Hz - 20kHz @7.1/2
Bias Frequency: 300kHz
Signal to Noise: Better than 65dB at 15ips
Bias System: Dolby HX Pro
Power: 115 - 240V 50/60Hz
Working position: Horizontal or Vertical
Dimensions: 440 X 80 X 398mm (W X H X D)
Other tech data: Built in monitor speaker
Special features: Real time tape counter